In-Plane Behavior of Adobe Masonry Wallets Strengthened Through Inorganic Matrix-Grid Composites

Adobe masonry (AM) dwellings are a considerable portion of existing buildings stock worldwide, particularly in developing countries. Several earthquakes occurred during last decades dramatically showed a high seismic vulnerability of such constructions, which are not generally engineered. Therefore, several research groups have been involved in the investigation about effective and viable retrofitting solutions for AM buildings. Currently, most of studies available in literature addressed the issue by means of experimental programs consisting of dynamic or static tests on reduced-or full-scale specimens, representing partial or complete AM dwellings. Nevertheless, in those works, limited or no attention was generally paid to the crucial issue of the spatial variability of material properties within AM, which can produce critical forms of mechanical response and premature failure. In this study, three series of seven AM wallets were tested under monotonic diagonal compression load: one series consisted of unreinforced specimens (used as benchmark) and the remaining series were strengthened with two textile reinforced matrix (TRM) systems, made of either hemp or glass meshes. Masonry joints and matrix were produced using the same mud mortar, which is a typical mortar of existing Italian AM buildings. Experimental outcomes of tests in terms of observed damage and response curves are presented, along with a comprehensive characterization of mortar and bricks. Then, with the aim to draw out general and robust trends about TRM effectiveness as strengthening solution in the improvement of shear strength and ductility capacity, the response variability was quantitatively investigated via statistical analysis of recorded stress– strain samples.